| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| A vulnerability in the stream reassembly component of Cisco Firepower Threat Defense Software, Cisco FirePOWER Services Software for ASA, and Cisco Firepower Management Center Software could allow an unauthenticated, remote attacker to bypass filtering protections. The vulnerability is due to improper reassembly of traffic streams. An attacker could exploit this vulnerability by sending crafted streams through an affected device. An exploit could allow the attacker to bypass filtering and deliver malicious requests to protected systems that would otherwise be blocked. |
| A vulnerability in the ingress flow creation functionality of Cisco Adaptive Security Appliance (ASA) could allow an unauthenticated, remote attacker to cause the CPU to increase upwards of 100% utilization, causing a denial of service (DoS) condition on an affected system. The vulnerability is due to incorrect handling of an internal software lock that could prevent other system processes from getting CPU cycles, causing a high CPU condition. An attacker could exploit this vulnerability by sending a steady stream of malicious IP packets that can cause connections to be created on the targeted device. A successful exploit could allow the attacker to exhaust CPU resources, resulting in a DoS condition during which traffic through the device could be delayed. This vulnerability applies to either IPv4 or IPv6 ingress traffic. This vulnerability affects Cisco Adaptive Security Appliance (ASA) and Firepower Threat Defense (FTD) Software that is running on the following Cisco products: 3000 Series Industrial Security Appliances (ISA), ASA 5500 Series Adaptive Security Appliances, ASA 5500-X Series Next-Generation Firewalls, ASA Services Module for Cisco Catalyst 6500 Series Switches and Cisco 7600 Series Routers, Adaptive Security Virtual Appliances (ASAv), Firepower 2100 Series Security Appliances, Firepower 4110 Security Appliances, Firepower 9300 ASA Security Modules. Cisco Bug IDs: CSCvf63718. |
| A vulnerability in the detection engine of Cisco Firepower System Software could allow an unauthenticated, remote attacker to bypass a configured file action policy to drop the Server Message Block (SMB) protocol if a malware file is detected. The vulnerability is due to how the SMB protocol handles a case in which a large file transfer fails. This case occurs when some pieces of the file are successfully transferred to the remote endpoint, but ultimately the file transfer fails and is reset. An attacker could exploit this vulnerability by sending a crafted SMB file transfer request through the targeted device. An exploit could allow the attacker to pass an SMB file that contains malware, which the device is configured to block. This vulnerability affects Cisco Firepower System Software when one or more file action policies are configured, on software releases prior to 6.2.3. Cisco Bug IDs: CSCvc20141. |
| A vulnerability in the Transport Layer Security (TLS) library of Cisco Adaptive Security Appliance (ASA) Software and Cisco Firepower Threat Defense (FTD) Software could allow an unauthenticated, remote attacker to trigger a reload of the affected device, resulting in a denial of service (DoS) condition. The vulnerability is due to insufficient validation of user-supplied input. An attacker could exploit this vulnerability by sending a malicious TLS message to an interface enabled for Secure Layer Socket (SSL) services on an affected device. Messages using SSL Version 3 (SSLv3) or SSL Version 2 (SSLv2) cannot be be used to exploit this vulnerability. An exploit could allow the attacker to cause a buffer underflow, triggering a crash on an affected device. This vulnerability affects Cisco ASA Software and Cisco FTD Software that is running on the following Cisco products: Adaptive Security Virtual Appliance (ASAv), Firepower Threat Defense Virtual (FTDv), Firepower 2100 Series Security Appliance. Cisco Bug IDs: CSCve18902, CSCve34335, CSCve38446. |
| A vulnerability in the web interface of the Cisco Adaptive Security Appliance (ASA) could allow an unauthenticated, remote attacker to cause an affected device to reload unexpectedly, resulting in a denial of service (DoS) condition. It is also possible on certain software releases that the ASA will not reload, but an attacker could view sensitive system information without authentication by using directory traversal techniques. The vulnerability is due to lack of proper input validation of the HTTP URL. An attacker could exploit this vulnerability by sending a crafted HTTP request to an affected device. An exploit could allow the attacker to cause a DoS condition or unauthenticated disclosure of information. This vulnerability applies to IPv4 and IPv6 HTTP traffic. This vulnerability affects Cisco ASA Software and Cisco Firepower Threat Defense (FTD) Software that is running on the following Cisco products: 3000 Series Industrial Security Appliance (ISA), ASA 1000V Cloud Firewall, ASA 5500 Series Adaptive Security Appliances, ASA 5500-X Series Next-Generation Firewalls, ASA Services Module for Cisco Catalyst 6500 Series Switches and Cisco 7600 Series Routers, Adaptive Security Virtual Appliance (ASAv), Firepower 2100 Series Security Appliance, Firepower 4100 Series Security Appliance, Firepower 9300 ASA Security Module, FTD Virtual (FTDv). Cisco Bug IDs: CSCvi16029. |
| A vulnerability in the Internet Key Exchange version 2 (IKEv2) protocol processing of Cisco Adaptive Security Appliance (ASA) Software, Cisco Firepower Threat Defense (FTD) Software, Cisco IOS Software, and Cisco IOS XE Software could allow an unauthenticated, remote attacker to cause a denial of service (DoS) condition on an affected device.
This vulnerability is due to insufficient input validation when processing IKEv2 messages. An attacker could exploit this vulnerability by sending crafted IKEv2 traffic to an affected device. A successful exploit could allow the attacker to cause the device to reload, resulting in a DoS condition on the affected device. |
| Multiple vulnerabilities in the CLI of Cisco Firepower Threat Defense (FTD) Software could allow an authenticated, local attacker to execute arbitrary commands with root privileges. For more information about these vulnerabilities, see the Details section of this advisory. |
| A vulnerability in the interaction of SIP and Snort 3 for Cisco Firepower Threat Defense (FTD) Software could allow an unauthenticated, remote attacker to cause the Snort 3 detection engine to restart.
This vulnerability is due to a lack of error-checking when SIP bidirectional flows are being inspected by Snort 3. An attacker could exploit this vulnerability by sending a stream of crafted SIP traffic through an interface on the targeted device. A successful exploit could allow the attacker to trigger a restart of the Snort 3 process, resulting in a denial of service (DoS) condition. |
| A vulnerability in Cisco Firepower Threat Defense (FTD) Software could allow an authenticated, local attacker to overwrite or append arbitrary data to system files using root-level privileges. The attacker must have administrative credentials on the device. This vulnerability is due to incomplete validation of user input for a specific CLI command. An attacker could exploit this vulnerability by authenticating to the device with administrative privileges and issuing a CLI command with crafted user parameters. A successful exploit could allow the attacker to overwrite or append arbitrary data to system files using root-level privileges. |
| A vulnerability in the processing of SSH connections for multi-instance deployments of Cisco Firepower Threat Defense (FTD) Software could allow an unauthenticated, remote attacker to cause a denial of service (DoS) condition on the affected device. This vulnerability is due to a lack of proper error handling when an SSH session fails to be established. An attacker could exploit this vulnerability by sending a high rate of crafted SSH connections to the instance. A successful exploit could allow the attacker to cause resource exhaustion, which causes a DoS condition on the affected device. The device must be manually reloaded to recover. |
| A vulnerability in the FTP inspection engine of Cisco Firepower Threat Defense (FTD) Software could allow an unauthenticated, remote attacker to cause an affected device to reload, resulting in a denial of service (DoS) condition. The vulnerability exists because the affected software fails to release spinlocks when a device is running low on system memory, if the software is configured to apply FTP inspection and an access control rule to transit traffic, and the access control rule is associated with an FTP file policy. An attacker could exploit this vulnerability by sending a high rate of transit traffic through an affected device to cause a low-memory condition on the device. A successful exploit could allow the attacker to cause a software panic on the affected device, which could cause the device to reload and result in a temporary DoS condition. |
| A vulnerability in the CLI of Cisco Firepower Threat Defense (FTD) Software could allow an authenticated, local attacker to perform a command injection attack. The vulnerability is due to insufficient input validation. An attacker could exploit this vulnerability by injecting commands into arguments for a specific command. A successful exploit could allow the attacker to execute commands with root privileges. |
| A vulnerability in the generic routing encapsulation (GRE) tunnel decapsulation feature of Cisco Firepower Threat Defense (FTD) Software could allow an unauthenticated, remote attacker to cause a denial of service (DoS) condition on an affected device. The vulnerability is due to a memory handling error when GRE over IPv6 traffic is processed. An attacker could exploit this vulnerability by sending crafted GRE over IPv6 packets with either IPv4 or IPv6 payload through an affected device. A successful exploit could allow the attacker to cause the device to crash, resulting in a DoS condition. |
| A vulnerability in the packet processing functionality of Cisco Firepower Threat Defense (FTD) Software could allow an unauthenticated, remote attacker to cause a denial of service (DoS) condition on an affected device. The vulnerability is due to inefficient memory management. An attacker could exploit this vulnerability by sending a high rate of IPv4 or IPv6 traffic through an affected device. This traffic would need to match a configured block action in an access control policy. An exploit could allow the attacker to cause a memory exhaustion condition on the affected device, which would result in a DoS for traffic transiting the device, as well as sluggish performance of the management interface. Once the flood is stopped, performance should return to previous states. |
| A vulnerability in the local malware analysis process of Cisco Firepower Threat Defense (FTD) Software could allow an unauthenticated, remote attacker to cause a denial of service (DoS) condition on the affected device. This vulnerability is due to insufficient error handling in the local malware analysis process of an affected device. An attacker could exploit this vulnerability by sending a crafted file through the device. A successful exploit could allow the attacker to cause the local malware analysis process to crash, which could result in a DoS condition. Notes: Manual intervention may be required to recover from this situation. Malware cloud lookup and dynamic analysis will not be impacted. |
| Multiple vulnerabilities in the Server Message Block (SMB) Protocol preprocessor detection engine for Cisco Firepower Threat Defense (FTD) Software could allow an unauthenticated, adjacent or remote attacker to cause a denial of service (DoS) condition. For more information about these vulnerabilities, see the Details section of this advisory. |
| A vulnerability in the HTTP traffic filtering component of Cisco Firepower Threat Defense Software, Cisco FirePOWER Services Software for ASA, and Cisco Firepower Management Center Software could allow an unauthenticated, remote attacker to bypass filtering protections. The vulnerability is due to improper handling of HTTP requests, including those communicated over a secure HTTPS connection, that contain maliciously crafted headers. An attacker could exploit this vulnerability by sending malicious requests to an affected device. An exploit could allow the attacker to bypass filtering and deliver malicious requests to protected systems, allowing attackers to deliver malicious content that would otherwise be blocked. |
| A vulnerability in the VPN System Logging functionality for Cisco Firepower Threat Defense (FTD) Software could allow an unauthenticated, remote attacker to cause a memory leak that can deplete system memory over time, which can cause unexpected system behaviors or device crashes. The vulnerability is due to the system memory not being properly freed for a VPN System Logging event generated when a VPN session is created or deleted. An attacker could exploit this vulnerability by repeatedly creating or deleting a VPN tunnel connection, which could leak a small amount of system memory for each logging event. A successful exploit could allow the attacker to cause system memory depletion, which can lead to a systemwide denial of service (DoS) condition. The attacker does not have any control of whether VPN System Logging is configured or not on the device, but it is enabled by default. |
| Multiple Cisco products are affected by a vulnerability in the Snort detection engine that could allow an unauthenticated, remote attacker to bypass a configured File Policy for HTTP. The vulnerability is due to incorrect detection of modified HTTP packets used in chunked responses. An attacker could exploit this vulnerability by sending crafted HTTP packets through an affected device. A successful exploit could allow the attacker to bypass a configured File Policy for HTTP packets and deliver a malicious payload. |
| A vulnerability in the web services interface of Cisco Adaptive Security Appliance (ASA) Software and Cisco Firepower Threat Defense (FTD) Software could allow an unauthenticated, remote attacker to conduct directory traversal attacks and read sensitive files on a targeted system. The vulnerability is due to a lack of proper input validation of URLs in HTTP requests processed by an affected device. An attacker could exploit this vulnerability by sending a crafted HTTP request containing directory traversal character sequences to an affected device. A successful exploit could allow the attacker to view arbitrary files within the web services file system on the targeted device. The web services file system is enabled when the affected device is configured with either WebVPN or AnyConnect features. This vulnerability cannot be used to obtain access to ASA or FTD system files or underlying operating system (OS) files. |
