| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| Improper session management in D-Link Wireless N 300 ADSL2+ Modem Router DSL-124 ME_1.00 allows attackers to execute a session hijacking attack via spoofing the IP address of an authenticated user. |
| Node.js versions which bundle an unpatched version of OpenSSL or run against a dynamically linked version of OpenSSL which are unpatched are vulnerable to the Marvin Attack - https://people.redhat.com/~hkario/marvin/, if PCKS #1 v1.5 padding is allowed when performing RSA descryption using a private key. |
| A vulnerability was found in Bdtask Wholesale Inventory Management System up to 20240311. It has been declared as problematic. Affected by this vulnerability is an unknown functionality. The manipulation leads to session fixiation. The attack can be launched remotely. The exploit has been disclosed to the public and may be used. The identifier VDB-257245 was assigned to this vulnerability. NOTE: The vendor was contacted early about this disclosure but did not respond in any way. |
| Mailcow through 2024-11b has a session fixation vulnerability in the web panel. It allows remote attackers to set a session identifier when HSTS is disabled on a victim's browser. After a user logs in, they are authenticated and the session identifier is valid. Then, a remote attacker can access the victim's web panel with the same session identifier. |
| Improper session management in Elber REBLE310 Firmware v5.5.1.R , Equipment Model: REBLE310/RX10/4ASI allows attackers to execute a session hijacking attack. |
| Successful exploitation of the vulnerability could allow an unauthenticated attacker to obtain a valid session ID with administrator privileges by spoofing the login request, potentially allowing the attacker to modify the behaviour of the access point. |
| Password Pusher is an open source application to communicate sensitive information over the web. A vulnerability has been reported in versions 1.50.3 and prior where an attacker can copy the session cookie before a user logs out, potentially allowing session hijacking. Although the session token is replaced and invalidated upon logout, if an attacker manages to capture the session cookie before this process, they can use the token to gain unauthorized access to the user's session until the token expires or is manually cleared. This vulnerability hinges on the attacker's ability to access the session cookie during an active session, either through a man-in-the-middle attack, by exploiting another vulnerability like XSS, or via direct access to the victim's device. Although there is no direct resolution to this vulnerability, it is recommended to always use the latest version of Password Pusher to best mitigate risk. If self-hosting, ensure Password Pusher is hosted exclusively over SSL connections to encrypt traffic and prevent session cookies from being intercepted in transit. Additionally, implement best practices in local security to safeguard user systems, browsers, and data against unauthorized access. |
| A flaw was found in Keycloak. In Keycloak where a user can accidentally get access to another user's session if both use the same device and browser. This happens because Keycloak sometimes reuses session identifiers and doesn’t clean up properly during logout when browser cookies are missing. As a result, one user may receive tokens that belong to another user. |
| All-Dynamics Software enlogic:show 2.0.2 contains a session fixation vulnerability that allows attackers to set a predefined PHP session identifier during the login process. Attackers can forge HTTP GET requests to welcome.php with a manipulated session token to bypass authentication and potentially execute cross-site request forgery attacks. |
| A UAA configured with multiple identity zones, does not properly validate session information across those zones. A User authenticated against a corporate IDP can re-use their jsessionid to access other zones. |
| An attacker who can spoof the IP address and the User-Agent of a logged-in user can takeover the session because of flaws in the self-developed session management. If two users access the web interface from the same IP they are logged in as the other user. |
| Issue summary: A timing side-channel which could potentially allow recovering
the private key exists in the ECDSA signature computation.
Impact summary: A timing side-channel in ECDSA signature computations
could allow recovering the private key by an attacker. However, measuring
the timing would require either local access to the signing application or
a very fast network connection with low latency.
There is a timing signal of around 300 nanoseconds when the top word of
the inverted ECDSA nonce value is zero. This can happen with significant
probability only for some of the supported elliptic curves. In particular
the NIST P-521 curve is affected. To be able to measure this leak, the attacker
process must either be located in the same physical computer or must
have a very fast network connection with low latency. For that reason
the severity of this vulnerability is Low.
The FIPS modules in 3.4, 3.3, 3.2, 3.1 and 3.0 are affected by this issue. |
| Non constant time cryptographic operation in Devolutions.XTS.NET 2024.11.19 and earlier allows an attacker to render half of the encryption key obsolete via a timing attacks |
| SCRAM (Salted Challenge Response Authentication Mechanism) is part of the family of Simple Authentication and Security Layer (SASL, RFC 4422) authentication mechanisms. Prior to version 3.2, a timing attack vulnerability exists in the SCRAM Java implementation. The issue arises because Arrays.equals was used to compare secret values such as client proofs and server signatures. Since Arrays.equals performs a short-circuit comparison, the execution time varies depending on how many leading bytes match. This behavior could allow an attacker to perform a timing side-channel attack and potentially infer sensitive authentication material. All users relying on SCRAM authentication are impacted. This vulnerability has been patched in version 3.1 by replacing Arrays.equals with MessageDigest.isEqual, which ensures constant-time comparison. |
| A Session Fixation vulnerability existed in Payload's SQLite adapter due to identifier reuse during account creation. A malicious attacker could create a new account, save its JSON Web Token (JWT), and then delete the account, which did not invalidate the JWT. As a result, the next newly created user would receive the same identifier, allowing the attacker to reuse the JWT to authenticate and perform actions as that user.
This issue has been fixed in version 3.44.0 of Payload. |
| OpenSSL 3.0.0 through 3.3.2 on the PowerPC architecture is vulnerable to a Minerva attack, exploitable by measuring the time of signing of random messages using the EVP_DigestSign API, and then using the private key to extract the K value (nonce) from the signatures. Next, based on the bit size of the extracted nonce, one can compare the signing time of full-sized nonces to signatures that used smaller nonces, via statistical tests. There is a side-channel in the P-364 curve that allows private key extraction (also, there is a dependency between the bit size of K and the size of the side channel). NOTE: This CVE is disputed because the OpenSSL security policy explicitly notes that any side channels which require same physical system to be detected are outside of the threat model for the software. The timing signal is so small that it is infeasible to be detected without having the attacking process running on the same physical system. |
| A malicious actor can fix the session of a PAM user by tricking the user to click on a specially crafted link to the PAM server. |
| An improper session validation allows an unauthenticated attacker to cause certain request notifications to be executed in the context of an incorrect user by spoofing the client IP address. |
| CKAN is an open-source DMS (data management system) for powering data hubs and data portals. Prior to 2.10.9 and 2.11.4, session ids could be fixed by an attacker if the site is configured with server-side session storage (CKAN uses cookie-based session storage by default). The attacker would need to either set a cookie on the victim's browser or steal the victim's currently valid session. Session identifiers are now regenerated after each login. This vulnerability has been fixed in CKAN 2.10.9 and 2.11.4 |
| Session Hijack vulnerability in Deprecated VMware Enhanced Authentication Plug-in could allow a malicious actor with unprivileged local access to a windows operating system can hijack a privileged EAP session when initiated by a privileged domain user on the same system. |
