| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| In the Linux kernel, the following vulnerability has been resolved:
ALSA: usb-audio: fix OOB write on Type II inbound URBs
data_ep_set_params() sizes each URB transfer buffer before it adds the
Format Type II transfer delimiter:
u->packets = urb_packs;
u->buffer_size = maxsize * u->packets;
if (fmt->fmt_type == UAC_FORMAT_TYPE_II)
u->packets++; /* for transfer delimiter */
u->urb = usb_alloc_urb(u->packets, GFP_KERNEL);
buffer_size is computed from the pre-increment packet count and never
recomputed, so for a Type II endpoint the buffer is one packet short of
the packet count the URB is built with.
prepare_inbound_urb() then lays out one iso frame per packet and never
consults buffer_size:
offs = 0;
for (i = 0; i < urb_ctx->packets; i++) {
urb->iso_frame_desc[i].offset = offs;
urb->iso_frame_desc[i].length = ep->curpacksize;
offs += ep->curpacksize;
}
urb->transfer_buffer_length = offs;
urb->number_of_packets = urb_ctx->packets;
The last descriptor therefore points one packet past the end of the
transfer buffer, where the host controller writes device data on every
inbound transfer. prepare_silent_urb() and prepare_playback_urb() bound
their fill loops by ctx->buffer_size, so only capture is affected.
fmt_type comes from the device's audio streaming descriptors, so any
device advertising a Type II capture format hits this once userspace sets
hw_params on the stream.
KASAN on 7.2.0-rc5 (arm64) with a dummy_hcd/raw-gadget device, one report
per inbound transfer:
BUG: KASAN: slab-out-of-bounds in dummy_timer
Write of size 64 at addr ffff0000186171c0 by task cons02/166
__asan_memcpy
dummy_timer
hrtimer_run_softirq
Allocated by task 166:
usb_alloc_coherent
snd_usb_endpoint_set_params
The buggy address is located 0 bytes to the right of
allocated 64-byte region [ffff000018617180, ffff0000186171c0)
Compute buffer_size after the delimiter packet has been accounted for,
and bound the fill loop by buffer_size, as prepare_silent_urb() already
does on the outbound side. This grows every Type II URB allocation by
one maxsize packet.
Discovered by XBOW, triaged by Baul Lee <baul.lee@xbow.com> |
| In the Linux kernel, the following vulnerability has been resolved:
tls: don't leave a full plaintext sk_msg ring unpushed
When the copy path in tls_sw_sendmsg_locked() adds the fragment that fills
the plaintext sk_msg ring, it does not set full_record, so the record is
left full and unpushed. A later splice() then adds to an already full
ring: sk_msg_page_add() has no fullness check of its own, so sg.end wraps
onto sg.start and the ring appears empty. Fragments added after that
overwrite live entries, and sg.size no longer matches what is reachable
between sg.start and sg.end, so pushing the record runs the scatterwalk off
the end of the scatterlist.
An unprivileged user can trigger this on a loopback TCP socket with the
"tls" ULP attached:
BUG: kernel NULL pointer dereference, address: 0000000000000008
RIP: 0010:memcpy_from_scatterwalk+0x32/0xc0
Call Trace:
skcipher_walk_next+0x1d1/0x2c0
gcm_encrypt_aesni_avx+0x1e9/0x220
bpf_exec_tx_verdict+0x3bb/0x860
tls_sw_sendmsg+0xa1a/0xca0
__sys_sendto+0x1da/0x1f0
Set full_record in the copy path when the ring becomes full, and push a
record that is already full on entry to the sendmsg loop. |
| IBM AIX 7.2, and 7.3 and IBM PowerVM VIOS 4.1 could allow a local attacker to execute arbitrary code due to an integer underflow. |
| IBM AIX 7.2, and 7.3 and IBM PowerVM VIOS 4.1 could allow a remote attacker to compromise the confidentiality and integrity of the system due to an out-of-bounds write. |
| IBM AIX 7.2, and 7.3 and IBM PowerVM VIOS 4.1 could allow a remote attacker to cause a denial of service due to a buffer overflow. |
| IBM AIX 7.2, and 7.3 and IBM PowerVM VIOS 4.1 could allow a remote attacker to execute arbitrary code due to a stack-based buffer overflow. |
| IBM AIX 7.2, and 7.3 and IBM PowerVM VIOS 4.1 could allow a remote attacker to execute arbitrary code due to a buffer overflow. |
| IBM AIX 7.2, and 7.3 and IBM PowerVM VIOS 4.1 could allow a remote attacker to execute arbitrary code due to a buffer overflow. |
| IBM AIX 7.2, and 7.3 and IBM PowerVM VIOS 4.1 could allow a remote attacker to execute arbitrary code due to a stack buffer overflow. |
| IBM AIX 7.2, and 7.3 and IBM PowerVM VIOS 4.1 could allow a remote attacker to execute arbitrary code due to a heap-based buffer overflow. |
| IBM AIX 7.2, and 7.3 and IBM PowerVM VIOS 4.1 could allow a remote attacker to cause a denial of service due to a stack-based buffer overflow. |
| IBM AIX 7.2, and 7.3 and IBM PowerVM VIOS 4.1 could allow a remote attacker to execute arbitrary code due to a heap-based buffer overflow. |
| IBM AIX 7.2, and 7.3 and IBM PowerVM VIOS 4.1 could allow a remote attacker to cause a denial of service due to a stack buffer overflow. |
| IBM AIX 7.2, and 7.3 and IBM PowerVM VIOS 4.1 could allow a local attacker to execute arbitrary code due to a buffer overflow. |
| IBM AIX 7.2, and 7.3 and IBM PowerVM VIOS 4.1 could allow a local attacker to cause a denial of service due to an out-of-bounds write. |
| IBM AIX 7.2, and 7.3 and IBM PowerVM VIOS 4.1 could allow a remote authenticated attacker to execute arbitrary code due to a stack-based buffer overflow. |
| NGINX Plus and NGINX Open Source have a vulnerability in the ngx_http_proxy_v2_module and ngx_http_grpc_module modules. This vulnerability exists when the proxy_http_version to 2 or grpc_pass directives are used to proxy HTTP/2 traffic, the ignore_invalid_headers directive is set to off, and the large_client_header_buffers directive size is larger than 2 megabytes. A remote, unauthenticated attacker, along with conditions beyond their control, could send large headers while creating an upstream request. This may cause a heap-based buffer overflow in the NGINX worker process leading to a restart. Additionally, attackers can execute code on systems with Address Space Layout Randomization (ASLR) disabled or when the attacker can bypass ASLR.
Note: Software versions which have reached End of Technical Support (EoTS) are not evaluated. |
| In the Linux kernel, the following vulnerability has been resolved:
ipvs: stop estimator after disabled calc phase
IPVS estimator kthread 0 starts with zeroed chain and tick limits until
its initial calculation phase completes. If network namespace teardown
clears ipvs->enable during that phase, ip_vs_est_calc_phase() can return
without installing positive limits.
The kthread can then continue into its main loop and drain
est_temp_list with zero chain_max, tick_max and est_max_count values.
Each enqueue consumes one available tick row, but est_count never
reaches the zero est_max_count value. After all rows are consumed, the
row lookup returns IPVS_EST_NTICKS and ip_vs_enqueue_estimator() writes
past the ticks and tick_len arrays.
Exit kthread 0 after the calculation phase if the kthread is stopping or
IPVS has been disabled. That keeps temporary estimators from being
drained after the limits failed to initialize.
Estimator kthreads can now self-exit before teardown or reload stops
kd->task. Keep an extra task reference after creation and release it
with kthread_stop_put(), so kd->task remains valid until the stop paths
consume that reference. |
| In the Linux kernel, the following vulnerability has been resolved:
xdp: reject clones that overrun skb_shared_info tailroom
xdpf_clone() clones broadcast copies into a single page and sets
frame_sz to PAGE_SIZE. __xdp_build_skb_from_frame() later treats that
page like a normal XDP frame and expects the usual skb_shared_info
tailroom at the end of the buffer.
The current check only rejects frames whose linear xdp_frame header,
headroom, and packet data exceed PAGE_SIZE. A source frame backed by a
larger allocation can still satisfy that check while extending into the
clone's required shared-info area. When such a clone is converted back
into an skb, build_skb_around() places skb_shared_info over live packet
bytes and later writes can corrupt XDP return metadata.
Reject clones unless their linear area fits inside
SKB_WITH_OVERHEAD(PAGE_SIZE), matching the tailroom requirement already
enforced by the XDP-to-skb conversion path. |
| In the Linux kernel, the following vulnerability has been resolved:
ip6_tunnel: clear skb2->cb[] in ip6ip6_err()
ip6ip6_err() clones an outer IPv6 ICMP error skb, pulls it to the
quoted inner IPv6 packet, and then passes the clone to icmpv6_send().
The clone still carries the outer packet's inet6_skb_parm in skb->cb.
If the outer packet had a Home Address Option, IP6CB(skb2)->dsthao
remains non-zero after skb_pull(). icmpv6_send() later calls
mip6_addr_swap(), which uses that stale dsthao offset against the quoted
inner packet. A malformed inner destination-options header can then make
the HAO lookup and address swap run past the end of the quoted packet
and corrupt skb_shared_info.
Clear skb2->cb[] before pulling the quoted inner IPv6 packet so the
reply path does not reuse metadata left by the outer IPv6 stack. |
