| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| In the Linux kernel, the following vulnerability has been resolved:
tipc: fix infinite loop in __tipc_nl_compat_dumpit
cmd->dumpit callback can return a negative errno, causing an infinite
loop due to the while(len) condition. As the loop never terminates,
genl_mutex is never released, and other tasks waiting on it starve in D
state.
Check dumpit's return value, propagate it and jump to err_out on error. |
| In the Linux kernel, the following vulnerability has been resolved:
bpf: Fix ld_{abs,ind} failure path analysis in subprogs
Usage of ld_{abs,ind} instructions got extended into subprogs some time
ago via commit 09b28d76eac4 ("bpf: Add abnormal return checks."). These
are only allowed in subprograms when the latter are BTF annotated and
have scalar return types.
The code generator in bpf_gen_ld_abs() has an abnormal exit path (r0=0 +
exit) from legacy cBPF times. While the enforcement is on scalar return
types, the verifier must also simulate the path of abnormal exit if the
packet data load via ld_{abs,ind} failed.
This is currently not the case. Fix it by having the verifier simulate
both success and failure paths, and extend it in similar ways as we do
for tail calls. The success path (r0=unknown, continue to next insn) is
pushed onto stack for later validation and the r0=0 and return to the
caller is done on the fall-through side. |
| This CVE ID has been rejected or withdrawn by its CVE Numbering Authority. |
| In Zabbix 7.4 the cryptographic key used for signing Frontend sessions has been erroneously written to the database seed. Currently the only known exploitation scenario is for deployments that utilize both - SAML authentication and guest users. In such cases the key can be used to forge valid session cookies, potentially leading to unauthorized access. For other Zabbix deployments this does not have a known impact. |
| Lemur manages TLS certificate creation. Prior to 1.9.2, lemur.users.service.update assigned a replacement password directly to users.password, while lemur/users/models.py registered User.hash_password only for the before_insert event. Because no before_update listener ran, administrator-initiated password changes through PUT /api/1/users/ were committed as plaintext. The affected user could no longer authenticate normally because bcrypt verification received an unhashed value. A database, backup, replica, query-log, or administrative read compromise exposed immediately usable credentials without offline cracking. The fix registers hashing for before_update and avoids rehashing values that already have a bcrypt prefix. This issue is fixed in version 1.9.2. |
| MyBB is free and open source forum software. Prior to 1.8.40, the User CP Buddy/Ignore List component does not validate reciprocal buddy-list updates correctly. The usercp.php?action=do_editlists delete handler removes the selected entry from the acting user's list and then updates mybb_users.buddylist for the target account. The reciprocal update searches for the deleted target UID instead of the acting user's UID and uses the unchecked array_search() return value as an array key. A false result can be converted to index 0, removing the target account's first stored buddy while leaving the actual reciprocal entry unchanged. The uniquely identifying implementation details include false converted to index 0. This issue is fixed in version 1.8.40. |
| In the Linux kernel, the following vulnerability has been resolved:
ntfs: sanitize MFT references returned from ntfs_lookup_inode_by_name()
ntfs_lookup_inode_by_name() returns MFT references read from directory
index entries on disk. These values are untrusted, but the function can
currently return an error-marked MFT reference to its callers without
validating it.
Callers later decode lookup failures with MREF_ERR(). A crafted NTFS image
can set the MREF error bit while leaving the low bits as an arbitrary
value, causing callers to consume a bogus pseudo-errno instead of treating
the lookup result as corrupted on-disk metadata.
Fix this at the source by normalizing every error-marked MFT reference
returned from ntfs_lookup_inode_by_name() to ERR_MREF(-EIO). Apply this to
all four directory lookup return paths so every caller gets a validated
result without needing additional checks or an API change.
This keeps the sanitization in the common lookup helper, which is cleaner
than duplicating validation in each caller. |
| A security flaw has been discovered in LB-LINK X-PRO 1.0.22-20231206. This affects an unknown function of the file /etc/config/easycwmp. The manipulation results in hard-coded credentials. It is possible to launch the attack remotely. Attacks of this nature are highly complex. The exploitability is reported as difficult. The exploit has been released to the public and may be used for attacks. The vendor was contacted early about this disclosure but did not respond in any way. |
| A flaw was found in libssh. Incorrect AES-GCM finalization checks in builds using the OpenSSL backend can effectively remove integrity protection, allowing an in-path attacker to modify plaintext on the wire without detection. |
| A vulnerability was identified in LB-LINK X-PRO 1.0.22-20231206. The impacted element is an unknown function of the file /etc/shadow. The manipulation leads to hard-coded credentials. It is possible to initiate the attack remotely. A high degree of complexity is needed for the attack. The exploitability is regarded as difficult. The exploit is publicly available and might be used. The vendor was contacted early about this disclosure but did not respond in any way. |
| In the Linux kernel, the following vulnerability has been resolved:
dma-mapping: move dma_map_resource() sanity check into debug code
dma_map_resource() uses pfn_valid() to ensure the range is not RAM.
However, pfn_valid() only checks for availability of the memory map for
a PFN but it does not ensure that the PFN is actually backed by RAM. On
ARM64 with SPARSEMEM (128MB section granularity), MMIO addresses that
share a section with RAM will falsely trigger the WARN_ON_ONCE and cause
dma_map_resource() to return DMA_MAPPING_ERROR.
This causes a WARNING on Raspberry Pi 4 during spi_bcm2835 probe because
the SPI FIFO register (0xfe204004) falls in the same sparsemem section
as the end of RAM (0xf8000000-0xfbffffff), both in section 31
(0xf8000000-0xffffffff).
Move the sanity check from dma_map_resource() into debug_dma_map_phys()
and replace the unreliable pfn_valid() with pfn_valid() &&
!PageReserved(), which correctly identifies actual usable RAM without
false positives for MMIO regions that happen to have struct pages.
Since dma_map_resource() is dma_map_phys(DMA_ATTR_MMIO), the check
applies equally to both APIs. Any non-reserved page represents kernel
memory to a sufficient degree that using DMA_ATTR_MMIO on it is almost
certainly wrong and risks breaking coherency on non-coherent platforms.
ZONE_DEVICE pages used for PCI P2P DMA (MEMORY_DEVICE_PCI_P2PDMA) have
PageReserved set, so they will not trigger a false positive.
The check no longer blocks the mapping and uses err_printk() to
integrate with dma-debug filtering. |
| In the Linux kernel, the following vulnerability has been resolved:
drm/msm: Fix iommu_map_sgtable() return value check and avoid WARN
Commit "iommu: return full error code from iommu_map_sg[_atomic]()"
changed iommu_map_sgtable() to return an ssize_t and negative values
in error cases, rather than a size_t and a zero.
Store the return value in the appropriate type and in case of error,
return it rather than WARNing.
Patchwork: https://patchwork.freedesktop.org/patch/719685/ |
| IBM i 7.6, 7.5, 7.4, and 7.3 could allow a remote authenticated attacker to execute arbitrary commands and obtain sensitive information due to improper privilege management. |
| Uncaught exception in .NET allows an authorized attacker to elevate privileges locally. |
| In the Linux kernel, the following vulnerability has been resolved:
mm/compaction: handle free_pages_prepare() properly in compaction_free()
free_pages_prepare() can fail but compaction_free() does not handle the
failure case. Failed pages should not be added back to cc->freepages for
future use, since they can be either PageHWPoison or free_page_is_bad()
and might cause data corruption. |
| In the Linux kernel, the following vulnerability has been resolved:
ext4: fix kernel BUG in ext4_write_inline_data_end
When the data=journal mount option is used, the ext4_journalled_write_end()
function incorrectly calls ext4_write_inline_data_end() without checking
if the EXT4_STATE_MAY_INLINE_DATA flag is still set on the inode.
If a previous attempt to convert the inline data to an extent failed (e.g.
due to ENOSPC), the EXT4_STATE_MAY_INLINE_DATA flag is cleared, but
the EXT4_INODE_INLINE_DATA flag remains set. In this scenario, the next
call to ext4_write_begin() will not prepare the inline data xattr for
writing, but ext4_journalled_write_end() will incorrectly attempt to write
to it, triggering a BUG_ON(pos + len > EXT4_I(inode)->i_inline_size) in
ext4_write_inline_data() since i_inline_size was not expanded.
Fix this by ensuring that ext4_journalled_write_end() only calls
ext4_write_inline_data_end() if the EXT4_STATE_MAY_INLINE_DATA flag is
set, mirroring the behavior of ext4_write_end() and ext4_da_write_end(). |
| IBM i 7.6, 7.5, 7.4, and 7.3 could allow a remote authenticated attacker to bypass security restrictions due to improper validation of an attacker-supplied user profile name. |
| A flaw has been found in Tenda CH, CP and TX3 V21.x/V22.x/V25.x/V26.x/V27.x. Affected by this issue is some unknown functionality of the component SSH. Executing a manipulation can lead to use of hard-coded password. It is possible to launch the attack remotely. The attack requires a high level of complexity. The exploitation is known to be difficult. The exploit has been published and may be used. |
| IBM i 7.6, 7.5, 7.4, and 7.3 is vulnerable to a privilege escalation as the result of a remote code execution vulnerability in the activation engine component. An authenticated attacker can execute a maliciously planted script with root authority. |
| In the Linux kernel, the following vulnerability has been resolved:
drm/xe: Return error on non-migratable faults requiring devmem
Non-migratable faults that require devmem incorrectly jump to the 'out'
label, which squashes the error code intended to be returned to the
upper layers. Fix this by returning -EACCES instead.
(cherry picked from commit c4508edb2c723de93717272488ea65b165637eac) |
