| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| A vulnerability in the remote access SSL VPN feature of Cisco Adaptive Security Appliance (ASA) Software and Cisco Firepower Threat Defense (FTD) Software could allow an authenticated, remote attacker to bypass a configured multiple certificate authentication policy and connect using only a valid username and password. This vulnerability is due to improper error handling during remote access VPN authentication. An attacker could exploit this vulnerability by sending crafted requests during remote access VPN session establishment. A successful exploit could allow the attacker to bypass the configured multiple certificate authentication policy while retaining the privileges and permissions associated with the original connection profile. |
| A vulnerability in ICMPv6 inspection when configured with the Snort 2 detection engine for Cisco Firepower Threat Defense (FTD) Software could allow an unauthenticated, remote attacker to cause the CPU of an affected device to spike to 100 percent, which could stop all traffic processing and result in a denial of service (DoS) condition. FTD management traffic is not affected by this vulnerability. This vulnerability is due to improper error checking when parsing fields within the ICMPv6 header. An attacker could exploit this vulnerability by sending a crafted ICMPv6 packet through an affected device. A successful exploit could allow the attacker to cause the device to exhaust CPU resources and stop processing traffic, resulting in a DoS condition. Note: To recover from the DoS condition, the Snort 2 Detection Engine or the Cisco FTD device may need to be restarted. |
| A vulnerability in the TLS 1.3 implementation of the Cisco Firepower Threat Defense (FTD) Software could allow an unauthenticated, remote attacker to cause the Snort 3 detection engine to unexpectedly restart. This vulnerability is due to a logic error in how memory allocations are handled during a TLS 1.3 session. Under specific, time-based constraints, an attacker could exploit this vulnerability by sending a crafted TLS 1.3 message sequence through an affected device. A successful exploit could allow the attacker to cause the Snort 3 detection engine to reload, resulting in a denial of service (DoS) condition. While the Snort detection engine reloads, packets going through the FTD device that are sent to the Snort detection engine will be dropped. The Snort detection engine will restart automatically. No manual intervention is required. |
| A vulnerability in the inter-device communication mechanisms between devices that are running Cisco Firepower Threat Defense (FTD) Software and devices that are running Cisco Firepower Management (FMC) Software could allow an authenticated, local attacker to execute arbitrary commands with root permissions on the underlying operating system of an affected device.
This vulnerability is due to insufficient validation of user-supplied input. An attacker could exploit this vulnerability by accessing the expert mode of an affected device and submitting specific commands to a connected system. A successful exploit could allow the attacker to execute arbitrary code in the context of an FMC device if the attacker has administrative privileges on an associated FTD device. Alternatively, a successful exploit could allow the attacker to execute arbitrary code in the context of an FTD device if the attacker has administrative privileges on an associated FMC device. |
| A vulnerability in the AnyConnect SSL VPN feature of Cisco Adaptive Security Appliance (ASA) Software and Cisco Firepower Threat Defense (FTD) Software could allow an unauthenticated, remote attacker to cause a denial of service (DoS) condition on an affected device. This vulnerability is due to an implementation error within the SSL/TLS session handling process that can prevent the release of a session handler under specific conditions. An attacker could exploit this vulnerability by sending crafted SSL/TLS traffic to an affected device, increasing the probability of session handler leaks. A successful exploit could allow the attacker to eventually deplete the available session handler pool, preventing new sessions from being established and causing a DoS condition. |
| A vulnerability in the Modbus preprocessor of the Snort detection engine could allow an unauthenticated, remote attacker to cause a denial of service (DoS) condition on an affected device.
This vulnerability is due to an integer overflow while processing Modbus traffic. An attacker could exploit this vulnerability by sending crafted Modbus traffic through an affected device. A successful exploit could allow the attacker to cause the Snort process to hang, causing traffic inspection to stop.Cisco has released software updates that address this vulnerability. There are no workarounds that address this vulnerability. |
| A vulnerability in the Simple Network Management Protocol version 3 (SNMPv3) access control functionality of Cisco Adaptive Security Appliance (ASA) Software and Cisco Firepower Threat Defense (FTD) Software could allow an unauthenticated, remote attacker to query SNMP data. This vulnerability is due to ineffective access control. An attacker could exploit this vulnerability by sending an SNMPv3 query to an affected device from a host that is not permitted by the SNMPv3 access control list. A successful exploit could allow the attacker to send an SNMP query to an affected device and retrieve information from the device. The attacker would need valid credentials to perform the SNMP query. |
| A vulnerability in the software-based SSL/TLS message handler of Cisco Adaptive Security Appliance (ASA) Software and Firepower Threat Defense (FTD) Software could allow an unauthenticated, remote attacker to cause an affected device to reload, resulting in a denial of service (DoS) condition. This vulnerability is due to insufficient validation of SSL/TLS messages when the device performs software-based SSL/TLS decryption. An attacker could exploit this vulnerability by sending a crafted SSL/TLS message to an affected device. A successful exploit could allow the attacker to cause the affected device to reload, resulting in a DoS condition. Note: Datagram TLS (DTLS) messages cannot be used to exploit this vulnerability. |
| A vulnerability in the detection engine of Cisco Firepower System Software could allow an unauthenticated, remote attacker to bypass configured file action policies if an Intelligent Application Bypass (IAB) with a drop percentage threshold is also configured. The vulnerability is due to incorrect counting of the percentage of dropped traffic. An attacker could exploit this vulnerability by sending network traffic to a targeted device. An exploit could allow the attacker to bypass configured file action policies, and traffic that should be dropped could be allowed into the network. Cisco Bug IDs: CSCvf86435. |
| A vulnerability in the internal packet-processing functionality of Cisco Firepower Threat Defense (FTD) Software for Cisco Firepower 2100 Series Security Appliances could allow an unauthenticated, remote attacker to cause an affected device to stop processing traffic, resulting in a denial of service (DoS) condition. The vulnerability is due to the affected software improperly validating IP Version 4 (IPv4) and IP Version 6 (IPv6) packets after the software reassembles the packets (following IP Fragmentation). An attacker could exploit this vulnerability by sending a series of malicious, fragmented IPv4 or IPv6 packets to an affected device. A successful exploit could allow the attacker to cause Snort processes on the affected device to hang at 100% CPU utilization, which could cause the device to stop processing traffic and result in a DoS condition until the device is reloaded manually. This vulnerability affects Cisco Firepower Threat Defense (FTD) Software Releases 6.2.1 and 6.2.2, if the software is running on a Cisco Firepower 2100 Series Security Appliance. Cisco Bug IDs: CSCvf91098. |
| Multiple vulnerabilities in the payload inspection for Ethernet Industrial Protocol (ENIP) traffic for Cisco Firepower Threat Defense (FTD) Software could allow an unauthenticated, remote attacker to bypass configured rules for ENIP traffic. These vulnerabilities are due to incomplete processing during deep packet inspection for ENIP packets. An attacker could exploit these vulnerabilities by sending a crafted ENIP packet to the targeted interface. A successful exploit could allow the attacker to bypass configured access control and intrusion policies that should be activated for the ENIP packet. |
| A vulnerability in the SIP inspection engine of Cisco Adaptive Security Appliance (ASA) Software and Cisco Firepower Threat Defense (FTD) Software could allow an unauthenticated, remote attacker to cause a crash and reload of an affected device, resulting in a denial of service (DoS) condition.The vulnerability is due to a crash that occurs during a hash lookup for a SIP pinhole connection. An attacker could exploit this vulnerability by sending crafted SIP traffic through an affected device. A successful exploit could allow the attacker to cause a crash and reload of the affected device. |
| A vulnerability in the upgrade process of Cisco Adaptive Security Appliance (ASA) Software and Cisco Firepower Threat Defense (FTD) Software could allow an authenticated, local attacker to inject commands that could be executed with root privileges on the underlying operating system (OS). This vulnerability is due to insufficient input validation. An attacker could exploit this vulnerability by uploading a crafted upgrade package file to an affected device. A successful exploit could allow the attacker to inject commands that could be executed with root privileges on the underlying OS. |
| A vulnerability in the CLI of Cisco Adaptive Security Appliance (ASA) Software and Cisco Firepower Threat Defense (FTD) Software could allow an authenticated, local attacker to execute arbitrary commands on the underlying operating system (OS) of an affected device. The vulnerability is due to insufficient input validation of commands that are supplied by the user. An attacker could exploit this vulnerability by authenticating to a device and submitting crafted input for specific commands. A successful exploit could allow the attacker to execute commands on the underlying OS with root privileges. To exploit this vulnerability, an attacker must have valid administrator-level credentials. |
| A vulnerability in the CLI of Cisco Firepower Threat Defense (FTD) Software could allow an authenticated, local attacker to execute arbitrary commands with root privileges on the underlying operating system of an affected device that is running in multi-instance mode. This vulnerability is due to insufficient validation of user-supplied command arguments. An attacker could exploit this vulnerability by submitting crafted input to the affected command. A successful exploit could allow the attacker to execute commands on the underlying operating system with root privileges. |
| A vulnerability in the software-based SSL/TLS message handler of Cisco Firepower Threat Defense (FTD) Software could allow an unauthenticated, remote attacker to trigger a reload of an affected device, resulting in a denial of service (DoS) condition. The vulnerability is due to insufficient validation of SSL/TLS messages when the device performs software-based SSL decryption. An attacker could exploit this vulnerability by sending a crafted SSL/TLS message through an affected device. SSL/TLS messages sent to an affected device do not trigger this vulnerability. A successful exploit could allow the attacker to cause a process to crash. This crash would then trigger a reload of the device. No manual intervention is needed to recover the device after the reload. |
| A vulnerability in the ICMP ingress packet processing of Cisco Firepower Threat Defense (FTD) Software for Cisco Firepower 4110 appliances could allow an unauthenticated, remote attacker to cause a denial of service (DoS) condition on an affected device. The vulnerability is due to incomplete input validation upon receiving ICMP packets. An attacker could exploit this vulnerability by sending a high number of crafted ICMP or ICMPv6 packets to an affected device. A successful exploit could allow the attacker to cause a memory exhaustion condition that may result in an unexpected reload. No manual intervention is needed to recover the device after the reload. |
| A vulnerability in the packet processing functionality of Cisco Firepower Threat Defense (FTD) Software could allow an unauthenticated, remote attacker to cause a denial of service (DoS) condition on an affected device. The vulnerability is due to inefficient memory management. An attacker could exploit this vulnerability by sending a large number of TCP packets to a specific port on an affected device. A successful exploit could allow the attacker to exhaust system memory, which could cause the device to reload unexpectedly. No manual intervention is needed to recover the device after it has reloaded. |
| A vulnerability in the SSL/TLS inspection of Cisco Firepower Threat Defense (FTD) Software for Cisco Firepower 2100 Series firewalls could allow an unauthenticated, remote attacker to cause a denial of service (DoS) condition on an affected device. The vulnerability is due to improper input validation for certain fields of specific SSL/TLS messages. An attacker could exploit this vulnerability by sending a malformed SSL/TLS message through an affected device. A successful exploit could allow the attacker to cause the affected device to reload, resulting in a DoS condition. No manual intervention is needed to recover the device after it has reloaded. |
| A vulnerability in the multi-instance feature of Cisco Firepower Threat Defense (FTD) Software could allow an authenticated, local attacker to escape the container for their Cisco FTD instance and execute commands with root privileges in the host namespace. The attacker must have valid credentials on the device.The vulnerability exists because a configuration file that is used at container startup has insufficient protections. An attacker could exploit this vulnerability by modifying a specific container configuration file on the underlying file system. A successful exploit could allow the attacker to execute commands with root privileges within the host namespace. This could allow the attacker to impact other running Cisco FTD instances or the host Cisco FXOS device. |
