| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| In the Linux kernel, the following vulnerability has been resolved:
dm_early_create: fix freeing used table on dm_resume failure
If dm_resume fails, the kernel attempts to free table with
dm_table_destroy, but the table was already instantiated with
dm_swap_table. This commit skips the call to dm_table_destroy in this
case. |
| IBM Security Verify Access 10.0 through 10.0.9.2 and IBM Verify Identity Access 11.0 through 11.0.3 and IBM Verify Identity Access Container 11.0 through 11.0.3 contains a format string injection vulnerability in the management interface that allows attackers to cause denial of service and information disclosure by crafting a malicious HTTP request. |
| In the Linux kernel, the following vulnerability has been resolved:
rxrpc: Don't move a peeked OOB message onto the pending queue
rxrpc_recvmsg_oob() takes a received oob message off recvmsg_oobq and,
if a response is needed, moves it onto the pending_oobq tree. However,
only the unlink from recvmsg_oobq is guarded by MSG_PEEK; the move onto
pending_oobq always runs.
As a result, reading a challenge with MSG_PEEK leaves the skb on
recvmsg_oobq while also adding it to pending_oobq. Since struct
sk_buff's rbnode shares storage with its next and prev pointers,
rb_insert_color() overwrites the list linkage, and the skb, which holds
a single reference, becomes reachable from both queues at once.
When the socket is closed both queues are drained in turn. While
draining recvmsg_oobq, __skb_unlink() follows the next and prev
pointers that rbnode has overwritten and writes to a bad address. Also,
as the skb holds a single reference but is freed from each queue, both
the skb and the connection reference it holds are released twice. This
leads to memory corruption and to a use-after-free caused by the
connection refcount underflow.
MSG_PEEK does not consume the message from the queue, so only unlink it
from recvmsg_oobq and then move it onto pending_oobq or free it when
the message is actually consumed. |
| In the Linux kernel, the following vulnerability has been resolved:
xfrm: nat_keepalive: avoid double free on send error
nat_keepalive_send() frees the keepalive skb whenever the IPv4 or IPv6
send helper reports an error.
That cleanup is only correct before the skb is handed to the output
path. Once ip_build_and_send_pkt() or ip6_xmit() takes ownership, the
networking stack may already have consumed the skb before returning an
error, so freeing it again is unsafe.
Handle the pre-handoff failure cases inside nat_keepalive_send_ipv4()
and nat_keepalive_send_ipv6(), where the caller still owns the skb, and
keep nat_keepalive_send() responsible only for family dispatch and the
unsupported-family cleanup path. |
| In the Linux kernel, the following vulnerability has been resolved:
staging: most: video: avoid double free on video register failure
comp_register_videodev() allocates a video_device with
video_device_alloc() and releases it if video_register_device() fails.
This can double free the video_device when __video_register_device()
reaches device_register() and that call fails:
video_register_device()
-> __video_register_device()
-> device_register() fails
-> put_device(&vdev->dev)
-> v4l2_device_release()
-> vdev->release(vdev)
-> video_device_release(vdev)
comp_register_videodev()
-> video_device_release(mdev->vdev)
Use video_device_release_empty() while registering the device so that
registration failure paths do not free mdev->vdev through vdev->release().
comp_register_videodev() then releases mdev->vdev exactly once on failure.
Restore video_device_release() after successful registration so the
registered device keeps its normal lifetime handling.
This issue was found by a static analysis tool I am developing. |
| In the Linux kernel, the following vulnerability has been resolved:
dmaengine: dma-axi-dmac: Properly free struct axi_dmac_desc
Use axi_dmac_free_desc() to free fully the descriptor at fail path when
call axi_dmac_alloc_desc() in axi_dmac_prep_peripheral_dma_vec(). |
| In the Linux kernel, the following vulnerability has been resolved:
PCI: endpoint: pci-ep-msi: Fix error unwind and prevent double alloc
pci_epf_alloc_doorbell() stores the allocated doorbell message array in
epf->db_msg/epf->num_db before requesting MSI vectors. If MSI allocation
fails, the array is freed but the EPF state may still point to freed
memory.
Clear epf->db_msg and epf->num_db on the MSI allocation failure path so
that later cleanup cannot double-free the array and callers can retry
allocation.
Also return -EBUSY when doorbells have already been allocated to prevent
leaking or overwriting an existing allocation. |
| In the Linux kernel, the following vulnerability has been resolved:
usb: gadget: net2280: Fix double free in probe error path
usb_initialize_gadget() installs gadget_release() as the release
callback for the embedded gadget device. The struct net2280 instance is
therefore released through gadget_release() when the gadget device's last
reference is dropped.
The probe error path calls net2280_remove(), which tears down the
partially initialized device and drops the gadget reference with
usb_put_gadget(). Calling kfree(dev) afterwards can free the same object
again.
Drop the explicit kfree() and let the gadget device release callback
handle the final free. This issue was found by a static analysis tool
I am developing. |
| SurrealDB before 1.1.1 contains a format string vulnerability in the rquickjs Exception::throw_type function when scripting is enabled. Attackers with scripting privileges can supply format string sequences in error inputs to read arbitrary memory or execute code with SurrealDB process privileges. |
| In the Linux kernel, the following vulnerability has been resolved:
tracing: Do not call map->ops->elt_free() if elt_alloc() fails
In paths where tracing_map_elt_alloc() failed to allocate objects,
the map->ops->elt_alloc() call was never successful. In this case,
map->ops->elt_free() should not be called. |
| In the Linux kernel, the following vulnerability has been resolved:
qed: fix double free in qed_cxt_tables_alloc()
If one of the later PF or VF CID bitmap allocations fails,
qed_cid_map_alloc() jumps to cid_map_fail and frees the previously
allocated CID bitmaps before returning an error. qed_cxt_tables_alloc()
then calls qed_cxt_mngr_free(), which invokes qed_cid_map_free()
again.
Fix this by setting each CID bitmap pointer to NULL after bitmap_free()
to avoid double free.
The bug was first flagged by an experimental analysis tool we are
developing for kernel memory-management bugs while analyzing
v6.13-rc1. The tool is still under development and is not yet publicly
available. Manual inspection confirms that the bug is still
present in v7.1-rc3.
Runtime reproduction was not attempted because exercising the failing
allocation path requires device-specific setup. |
| In the Linux kernel, the following vulnerability has been resolved:
mtd: fix double free and WARN_ON in add_mtd_device() error paths
When device_register() or mtd_nvmem_add() fails inside
add_mtd_device() for a partition, the error handling triggers
mtd_release() via put_device() or device_unregister(). mtd_release()
calls release_mtd_partition() which frees the mtd_info structure.
However, callers such as mtd_add_partition() and add_mtd_partitions()
also call free_partition() in their error paths, resulting in a double
free.
Additionally, release_mtd_partition() hits WARN_ON(!list_empty(
&mtd->part.node)) because the partition node is still linked in the
parent's partitions list when the release callback fires from the
add_mtd_device() error path.
Fix this by overriding dev->type and dev->release before put_device()
in the error paths, so that device_release() invokes a no-op function
instead of mtd_release(). For the mtd_nvmem_add() failure case,
device_unregister() is replaced with device_del() to separate the
device removal from the final kobject reference drop, allowing the
override to take effect before put_device() is called.
The callers' error paths (list_del + free_partition) remain the sole
owners of mtd_info lifetime on add_mtd_device() failure, which is the
expected contract.
The normal partition teardown path is not affected: del_mtd_device()
goes through kref_put() -> mtd_device_release() -> device_unregister()
with dev->type still set to &mtd_devtype, so mtd_release() ->
release_mtd_partition() continues to work correctly for the regular
removal case. |
| Calling wordexp with WRDE_APPEND in the GNU C Library version 2.0 to version 2.43 can cause the interface to return invalid memory in the we_wordv member, which on subsequent calls to wordfree may abort the process. |
| In the Linux kernel, the following vulnerability has been resolved:
ice: fix double-free of tx_buf skb
If ice_tso() or ice_tx_csum() fail, the error path in
ice_xmit_frame_ring() frees the skb, but the 'first' tx_buf still points
to it and is marked as valid (ICE_TX_BUF_SKB).
'next_to_use' remains unchanged, so the potential problem will
likely fix itself when the next packet is transmitted and the tx_buf
gets overwritten. But if there is no next packet and the interface is
brought down instead, ice_clean_tx_ring() -> ice_unmap_and_free_tx_buf()
will find the tx_buf and free the skb for the second time.
The fix is to reset the tx_buf type to ICE_TX_BUF_EMPTY in the error
path, so that ice_unmap_and_free_tx_buf().
Move the initialization of 'first' up, to ensure it's already valid in
case we hit the linearization error path.
The bug was spotted by AI while I had it looking for something else.
It also proposed an initial version of the patch.
I reproduced the bug and tested the fix by adding code to inject
failures, on a build with KASAN.
I looked for similar bugs in related Intel drivers and did not find any. |
| In the Linux kernel, the following vulnerability has been resolved:
octeontx2-pf: avoid double free of pool->stack on AQ init failure
otx2_pool_aq_init() frees pool->stack when mailbox sync or retry
allocation fails, but leaves the pointer unchanged. Later,
otx2_sq_aura_pool_init() unwinds the partial setup through
otx2_aura_pool_free(), which frees pool->stack again. The CN20K-specific
cn20k_pool_aq_init() implementation has the same bug in
its corresponding error path.
Set pool->stack to NULL immediately after the local free so the shared
cleanup path does not free the same stack again while cleaning up
partially initialized pool state.
The bug was first flagged by an experimental analysis tool we are
developing for kernel memory-management bugs while analyzing
v6.13-rc1. The tool is still under development and is not yet publicly
available. Manual inspection confirms that the bug is still present in
v7.1-rc3.
Runtime validation was not performed because reproducing this path
requires OcteonTX2/CN20K hardware. |
| In the Linux kernel, the following vulnerability has been resolved:
wifi: mac80211: fix fils_discovery double free on alloc failure
ieee80211_set_fils_discovery() calls kfree_rcu() on the old template
before allocating the replacement. If the kzalloc() then fails, it
returns -ENOMEM while link->u.ap.fils_discovery still points at the
object already queued for freeing. A later update or AP teardown
(ieee80211_stop_ap()) re-queues that same rcu_head; the second free is
caught by KASAN when the RCU sheaf is processed in softirq:
BUG: KASAN: double-free in rcu_free_sheaf (mm/slub.c:5850)
Free of addr ffff88800c065280 by task swapper/0/0
...
__rcu_free_sheaf_prepare (mm/slub.c:2634 mm/slub.c:2940)
rcu_free_sheaf (mm/slub.c:5850)
rcu_core (kernel/rcu/tree.c:2617 kernel/rcu/tree.c:2869)
handle_softirqs (kernel/softirq.c:622)
The buggy address belongs to the cache kmalloc-96 of size 96
Queue the old object for kfree_rcu() only after the new one is published,
matching ieee80211_set_probe_resp() and ieee80211_set_s1g_short_beacon(). |
| Redis before 8.8.0, in the unusual case where an authenticated attacker can execute RESTORE, allows remote code execution via a RESTORE payload where the same NACK (pending entry) is referenced by more than one consumer, because deleting both consumers via XGROUP DELCONSUMER leads to a double free. NOTE: this issue exists because of an incomplete fix for CVE-2026-25243. |
| In the Linux kernel, the following vulnerability has been resolved:
smb: client: fix query_info() replay double-free
A response-bearing attempt can return a replayable error and free its
response buffer. If SMB2_query_info_init() fails before the next send,
cleanup retains the previous buffer type and frees that response again.
Reset response bookkeeping before each attempt to prevent the stale free. |
| In the Linux kernel, the following vulnerability has been resolved:
smb: client: fix change notify replay double-free
A response-bearing attempt can return a replayable error and free its
response buffer. If SMB2_notify_init() fails before the next send, cleanup
retains the previous buffer type and frees that response again.
Reset response bookkeeping before each attempt to prevent the stale free. |
| In the Linux kernel, the following vulnerability has been resolved:
smb: client: fix query directory replay double-free
A response-bearing attempt can return a replayable error and free its
response buffer. If SMB2_query_directory_init() fails before the next send,
cleanup retains the previous buffer type and frees that response again.
Reset response bookkeeping before each attempt to prevent the stale free. |
